Metallic Expansion Joints - Power Technology

By downloading, you acknowledge that we may share your information with our partners and sponsors who may contact you directly with information on their products and services. Visit our privacy policy for more information about our services, how we may use, process and share your personal data, including information on your rights in respect of your personal data and how you can unsubscribe from future marketing communications.  Our services are intended for corporate subscribers and you warrant that the email address submitted is your corporate email address.

Thank you for submitting the form. Your enquiry will be submitted to the company. Short Radius Elbow

Metallic Expansion Joints - Power Technology

Please check your email to download the Product.

The basic element of a metallic expansion joint (MEJ) is the bellows, which is a flexible, corrugated tubular metal element to absorb movements in a piping system.

In the operating environment, the critical stresses and movements may act in axial, lateral or angular directions and the bellows must, therefore, be designed and dimensioned to accommodate these movements.

Metallic expansion joints are broadly broken into unrestrained assemblies and restrained assemblies.

The simplest type of expansion joint consists of a single bellow element welded to end fittings, normally flange or pipe ends. The single bellows can absorb small amounts of axial, lateral and angular movement with ease, but adequate anchors and guides must be provided.

This assembly consists of two bellows connected by a centre spool piece with flange or pipe ends. The universal arrangement allows greater axial, lateral and angular movements than a single bellow assembly. Increasing the centre spool length produces increased movement capability. Like the single, adequate anchors and guides must be provided.

Line pressure acts externally on the bellows by means of a pressure chamber. This allows a greater number of convolutions to be used for large axial movements, without fear of bellows instability. Externally pressurised expansion joints have the added benefit of self-draining convolutions if standing media is a concern. Anchors and guides are an essential part of a good installation.

The addition of tie rods to a single bellow assembly adds design flexibility to a piping system. The tie rods are attached to the pipe or flange with lugs that carry the pressure thrust of the system, eliminating the need for main anchors. With the assembly tied, the ability to absorb axial growth is lost. The only lateral movement can be absorbed with the tied expansion joint.

Similar in construction to a universal assembly except that tie rods absorb pressure thrust and limit movements to lateral offset and angulations. Large offset movements are possible in a universal assembly by increasing the distance between the two bellows.

When a hinged expansion Joint is used, movement is limited to angulation in one plane. Hinged assemblies are normally used in sets of two or three to absorb large amounts of expansion in a high-pressure piping system. Only low-spring forces are transmitted to the equipment.

The gimbal restraint is designed to absorb system pressure thrust and torsional twins while allowing angulation in any plane. Gimbal assemblies, when used in pairs or with a single-hinged unit, have the advantage of absorbing movements in multi-planar piping systems. The gimbal works the same as an automobile universal drive shaft.

Metallic Expansion Joints - Power Technology

Din Flange Power industry news, data and in-depth articles on the global trends driving power generation, renewables and innovation